This tutorial will guide you on how to find the sun and moon using Seestar S30 manually.

First, connect Seestar to your mobile device, enter the solar system mode, click the GoTo button after the sun/moon, and then on the next page, click Skip GoTo Direct Observation to join the preview page. (If looking for the sun, make sure the solar filter is installed correctly)

After entering the preview page, the lens will automatically rise. Since the S30 is equipped with dual lenses, there will be two preview interfaces. Click the upper left corner of the screen to switch to the wide-angle interface.

After the interface is switched, control the direction lever in the center of the screen to roughly adjust the lens to the direction of the sun/moon. The sun/moon will appear in the wide-angle lens. Then adjust the direction lever in the center of the screen to fine-tune the target position, or click the sun/moon in the center of the screen and click "Go" that appears on the screen again to accurately point the lens to the target. You can complete the search for the sun/moon. At this time, click the upper right corner again to switch to the shooting page and start shooting.